- Standby current: about 0.1 mA (standby mode automatically switches to energy saving state)

- Maximum load: 2A (maximum load power 48W) Working RF frequency: 433MHz.Encoding system: 1527 learning passwords.Maximum load: 2A (maximum load power 48W)

【EASY and SAFE】The wireless remote control switch is easy to use and safety. the Working Voltage: DC3.6V-DC24V; Max Load: 2A Wireless control, easy to use, learn, relearn and control.

【STRONG SIGNAL】Adopts RF technology ,allowing independent control without mutual interference.it can pass through walls, floors and doors, control receiver from any place within a reliable distance.Max range is up to 328ft with no obstacle.

【Widely used】The wireless RF switch is a learning code wide range of applications from simple domestic remote control to autonomous control , such as DIY, LED lights, lamp beads, Christmas tree light strings, light control switches etc.

【4 Work Modes】Momentary Mode, Toggle Mode, Latched Mode, Delay Mode . Tips: If you encounter any problems during use, please feel free to contact us ,we will serve you wholeheartedly, thank you very much!

RECEIVER OPERATING MODE SETTINGS

Momentary Mode Setting

Press the learning button of the receiver once , it comes into Momentary setting mode.

Wait for a moment, the LED indicator of the receiver board will be on.

Press the remote button,the LED indicator will flash 3 times and then go out, the setting is successful.

Toggle Mode Setting

Press the learning button of the receiver twice, it comes into Toggle setting mode.

Wait for a moment, the LED indicator of the receiver board will be on.

Press the remote button,the LED indicator will flash 3 times and then go out, the setting is successful.

Latching Mode Setting

When selecting the Latching Mode, two different buttons need to be set, the first button is set to "ON", and the second button is set to "OFF".

Press the learning button of the receiver 3 times,it comes into Latching setting mode.

Wait for a moment, the LED indicator of the receiver board will be on.

Press the remote control button “ON”, the LED indicator flashes 3 times.

Press the remote control button “OFF”, the LED indicator flashes 3 times and then goes out, the setting is successful.

Delay Mode Setting

Press the learning button of the receiver 4 times, with a delay of 5 seconds.

Press the learning button of the receiver 5 times, with a delay of 10 seconds.

Press the learning button of the receiver 6 times, with a delay of 15 seconds.

Press the learning button of the receiver 7 times, with a delay of 20 seconds.

Wait for a moment, the LED indicator of the receiver board will be on.

Press the remote button,the LED indicator will flash 3 times and then go out, the setting is successful.

Automatic energize when power on

Press and hold the learning button until the led indicator light flashes, the setting is complete.

How to reset

Press the learning button of the receiver 8 times, the receiver will clear all remote control data in the memory.

After the receiver resets the data, the remote control needs to be re-paired with the receiver to control the receiver.

Note:

The blue output wire is ALWAYS Vcc (input voltage)! The device only switches the ground.